Notificator Documentation

Open source device firmware

Build your own Notificator.

Connect a compatible ESP32 device over USB, choose its firmware, and install it securely from your browser. No development environment is required.

Step 1

Choose a firmware

Loading releases
Board Checking…
Version Checking…
Channel Stable

Step 2

Connect and install

This browser cannot access USB devices. Open this page in Chrome or Edge on a desktop computer.

The installer needs a secure HTTPS connection before it can access USB devices.

This performs a clean installation. Saved Wi-Fi and MQTT settings on the device will be erased. You can configure them again in the Notificator setup portal after restart.

Before you begin

A three-minute setup

  1. 01
    Use a data cableSome USB cables provide power only.
  2. 02
    Open Chrome or EdgeWeb Serial is not available in Safari or iOS browsers.
  3. 03
    Select the USB deviceChoose the ESP32 serial port when prompted.
  4. 04
    Complete local setupJoin the WPNOTIF network after the device restarts.